Gold's Gym GGCCBE8057.0 manual Pulley Guards are oriented as shown

56.Wrap the Low Cable (80) under a Small Pulley (74). Attach the Small Pulley and two Half Pulley Guards (91) to the Weight Carriage Base (20) with an M10 x 45mm Bolt (140) and an M10 Nylon Locknut (153). Make sure that the Half

Pulley Guards are oriented as shown.

57.Attach the Low Cable (80) to the “U”-bracket (158) with an M8 Nylon Locknut (170) and an M8 Washer (164) (see the inset drawing). Tighten the Nylon Locknut exactly two full turns onto the Cable.

56
	80
	91	74
		91
	153
		140
	20
57
		170
		164
	158	80
158	170
	164
80

58.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on the following page.

Before using the weight bench, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 34 for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables. See MAINTENANCE on page 33.

28