Gold's Gym GGCCBE8057.0 manual Sure that the Cable Trap is oriented to hold

34. See the CABLE DIAGRAM on page 34 to iden-	34
tify the cables as you assemble them.
Identify the Arm Cable (145). Grease an M8 x		143	Grease
22mm Shoulder Bolt (143). Attach the Cable to
the Left Adjustment Bracket (25) with the			145
Shoulder Bolt and an M8 Nylon Locknut (170).			170
Make sure that the flat edge of the cable is
			25
against the Adjustment Bracket. Do not over-
tighten the Shoulder Bolt; the Cable must
pivot easily.
			143	145
			25
				170
35. Identify the two “V”-pulleys (75), which are	35
wider than the other pulleys. Wrap the Arm
Cable (145) over a “V”-pulley. Attach the “V”-pul-			153
ley, a Large Cable Trap (77), and two Full Pulley
Guards (76) to the indicated bracket on the			76 77	76
Center Upright (13) with an M10 x 60mm Bolt
(133) and an M10 Nylon Locknut (153). Make
sure that the Cable Trap is oriented to hold	13		75	133
the Cable in the groove of the “V”-pulley.
			145
36. Wrap the Arm Cable (145) under a Small Pulley	36
(74). Attach the Small Pulley and two Half Pulley
Guards (91) to the Double “U”-bracket (98) with
an M10 x 45mm Bolt (140) and an M10 Nylon
Locknut (153). Make sure that the Half Pulley
Guards are oriented as shown.
			145
			74	153
			98	91
			91
			140

20