Maintenance | Graco 311511G specs

Fluid Circulation

Maintenance

•Check and add TSL to B side pump wet-cup daily.

•Check ISO lube bottle for significant discoloration or crystallization daily. Replace with fresh TSL when needed.

•Ensure ISO (A) pump is down and in PARK position during every shutdown.

•Keep any ISO (A) fluid from being exposed to atmo- sphere to prevent crystallization.

•Remove inlet filter screen plug (V, Y) and clean screens if increased unbalanced pressures between A and B is noticed or as needed for fluids used. Also clean after flushing.

•Close gun fluid shutoff valves when not in use.

•If using a Fusion Air Purge gun, add grease with grease gun per manual.

•Clean gun filter screens and mix chamber ports reg- ularly, or when increased unbalanced pressures between A and B is noticed. See gun manual.

•Use lithium grease or Iso Pump Oil on all threaded fluid fittings on the “A” side.

311511G

33

Image 33

Graco 311511G important safety instructions Maintenance

Contents

Reactor A-20 Related Manuals Contents Proportioner 50 ft 15 m 10 ft 3 m SystemsPart Approvals Electric Shock Hazard Fire and Explosion Hazard Moving Parts Hazard Key for FIG Typical Installation, without Circulation Typical Installation, with Circulation Foam Self-Ignition Moisture Sensitivity of IsocyanatesIsocyanate Hazard Keep Components a and B Separate Component Identification Typical Installation Key AP Park/Run Switch Controls and Indicators Flushing Pressure Relief Procedure Setup Determine Power SourceLocate Reactor A-20 Electrical Requirements Step One Connect Electrical Cord Configure to Supply Power Terminal Blocks Power Jumper Location Ground System Iso Pump Lubrication System SetupFluid Supply Connections Air Supply Connection Connect FTS and Heated Dual Whip Hose Connect Heated Hose Recirculation / Pressure Relief Lines Close Gun Fluid Manifold Valves a and B Connect Whip Hose to Gun Fluid ManifoldPressure Check Hose Fluid Temperature Sensor FTS Calibration Initial StartupLoad Fluid with Feed Pumps Digital Temperature Controllers To change or enter the set point, proceed as followsA1 A2 A3 To change back to Fahrenheit units To change to Celsius units Over Temperature Alarms Fluid Heater Temperature OffsetHose Heat Manual Mode Supply Wet-Cups with Throat Seal Liquid Spray Spraying Setup Spray Adjustments Shutdown Operation Daily Start-up Procedure Ti2414A Circulation Through Reactor Fluid Circulation CKN Circulation Through Gun Manifold Maintenance Category Data Technical Data Technical Data 311511G Graco Information Graco Standard Warranty