Configure to Supply Power
Both cord connection AND jumper positioning 
steps on page 16 must be completed.
Setup
green to ground (GND). See page 16 for proper jumper positions.
Disregard terminal numbers on disconnect switch 
blocks. Wire to positions shown.
Step One - Connect Electrical Cord
Disregard terminal numbers on disconnect switch
blocks. Wire to positions shown. Terminals will accept up to #8 AWG (10 mm2) conductors.
|
|
| , |
. | , | , | , |
|
|
| , |
, |
| , |
|
. |
ti8611a
0%
'2.$
1. | Remove and retain two screws from lower front |
| shroud and remove. |
2. | Connect main power cord to electrical console as |
| follows: |
| a. Feed power cord through strain relief (SR) on |
230V, 3 Phase Delta: Use a screwdriver to connect three power leads to top terminals L1, L2, and L3. Connect green to ground (GND). See page 16 for proper jumper positions.
right side of unit. Push black die release lever |
(RL) down to release contacts block (PD) for |
easy wiring. |
b. Connect power leads to Power Disconnect |
Switch (PD). Snap contacts block (PD) back |
onto switch. |
c. Tighten strain relief nut. |
. | , | , | , |
|
|
| , |
| , , , | ||
. | |||
ti8612a
0%
'2.$
d. | Strain relief accepts cords 0.59 to 1.0 in. |
| mm) diameter. |
e. | Connect ground wire to ground lug (GL). |
380V, 3 Phase WYE (as shipped from factory): Use a screwdriver to connect three power leads to the top terminals L1, L2, and L3. Connect neutral to N. Connect green to ground (GND). See page 16 for proper jumper positions.
RL
PD
SR
GL
ti8608a
3.Replace lower front shroud. Reinstall the two screws retained in Step 1.
230V, 1 Phase: Use a screwdriver to connect two power leads to the top terminals N and L2 positions. Connect
|
|
| , |
. | , | , | , |
|
|
| , |
. , , , | 0% |
. | |||
|
|
| '2.$ |
ti8613a
311511G | 15 |
