Getting Started

Acquiring Satellite

Signals

It may take 30 to 60 seconds to acquire signals.

1.Go outdoors to an open area.

2.Make sure that the front of the Edge is oriented toward the sky.

3.Wait while the Edge searches for satellites.

Do not begin moving until the locating satellite page disappears.

Note: To turn off the GPS receiver and use the Edge indoors, see page 45.

Optional ANT+ Sensors

note: If you do not need to set up ANT+ sensors, you can skip this step.

To use an ANT+ sensor during your ride, you must install it and pair it with the Edge.

For heart rate monitor instructions, see page 21.

For GSC10 speed and cadence sensor instructions, see page 25.

For third-party ANT+ sensors, see page 30, refer to the manufacturer’s instructions, and go to www.garmin.com/intosports.



Edge 500 Owner’s Manual