Graco 500 note, Reset, Reset

Sensor arm	Spoke
	magnet
indication line

GSC 10

Pedal magnet

GSC 10 and Magnet

Alignment

6.Loosen the screw on the sensor arm.

7.Move the sensor arm to within 5 mm of the spoke magnet.

You can also tilt the GSC 10 closer to either magnet for improved alignment.

ANT+ Sensors

8.Press the Reset button on the GSC 10.

The LED turns red, then green.

9.Pedal to test the sensor alignment.

The red LED blinks each time the pedal magnet passes the sensor. The green LED blinks each time the spoke magnet passes the sensor arm.

note: The LED blinks for the first

60 passes after a reset. Press Reset again if you require additional passes.

10.When everything is aligned and working correctly, tighten the cable ties, the sensor arm, and the spoke magnet.

Edge 500 Owner’s Manual