2.Use a coin to twist the cover counter-clockwise so the arrow on the cover points to OPEN.

3.Remove the cover and battery.

4.Wait 30 seconds.

5.Insert the new battery with the positive side facing up.

Note: Be careful not to damage or lose the O-ring gasket on the cover.

6.Use a coin to twist the cover clockwise so the arrow on the cover points to CLOSE.

ANT+ Sensors

Installing the GSC 10

Both magnets must be aligned with their respective indication lines for the Edge to receive data.

1.Place the GSC 10 on the rear chain stay (on the side opposite the drive train).

NOTE: Place the flat rubber pad or the triangle-shaped rubber pad between the GSC 10 and the chain stay for stability.

Edge 500 Owner’s Manual

5