ANT+ Sensors

Reset button

Indication line

Cable ties

GSC 10 on Rear

Chain Stay

2.Loosely attach the GSC 10 using two cable ties.

3.Attach the pedal magnet to the crank arm using the adhesive mount and a cable tie.

The pedal magnet must be within 5 mm of the GSC 10. The indication line on the pedal magnet must line up with the indication line on the GSC 10.

Cable tie

Indication line

Pedal Magnet on

Crank Arm

4.Unscrew the spoke magnet from the plastic piece.

5.Place the spoke in the groove of the plastic piece and tighten slightly.

The spoke magnet can face away from the GSC 10 if there is not enough room between the sensor arm and the spoke. The spoke magnet must line up with the indication line on the sensor arm.

26

Edge 500 Owner’s Manual