Setup
Connect Air Line
NOTE:
•If your regulated air source does not have a filter, install an air filter (G) on each air line to ensure a dry, clean air supply to the gun. Dirt and moisture can ruin the appearance of your finished workpiece. See FIG. 5.
•You must install a separate air pressure regulator (F) on the CYL, FAN, and ATOM air lines to control air pressure to the gun. See FIG. 6 and FIG. 7.
•Install a bleed type air shutoff valve (E) on each gun air supply line, down- stream of the gun air regulator, to shut off air to the gun.
Setup
1.The gun cylinder, fan, and atomization air must be supplied and regulated separately. To regulate air remotely, use solenoids (see FIG. 6 and FIG. 7).
NOTE: The three air inlet fittings accept 6 mm OD tubing.
2.Connect each air hose (D) to a regulated air supply line (H).
H
G | F E D ti01990a |
FIG. 5: Connect Air Line
313869B | 13 |
