Installation
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod [0.75 in. (19 mm) diameter maximum], insert the bar (A) through the hole in the manifold as shown in FIG. 3.
NOTE: Use the 1/8 in. alignment slot (P) to assist in orienting the gun.
Secure the gun to the bar by tightening the mounting screw (B).
|
| A |
B |
| |
P | TI14433A | |
|
|
FIG. 3: Reciprocating Arm Mount
Stationary Support
To mount the gun on a stationary support, refer to FIG. 4 and to the correct mounting hole lay- out for your gun, page 30 - 31.
C
Guns with manifold
C
TI14434A
1.Align the gun or manifold with the align- ment pins. Locate alignment slot and holes per the mounting hole layout.
2.Secure the gun to the support with two M8 x 1.25 capscrews (C). The screws must be long enough to engage the threaded holes to a depth of 1/4 in. (6 mm).
TI14435A
Guns without manifold
FIG. 4: Stationary Support Mount
12 | 313869B |
