Troubleshooting
Pressure Adjust Potentiometer
Removal
Perform Pressure Relief Procedure; page 8. Wait 5 minutes before servicing.
1. Remove four screws (38) and cover (96).
96
38 | ti13493a |
2.Remove two screws and control panel.
3.Disconnect potentiometer connector (C) from motor
control board (95).
95
C
ti12997a
4.Use allen wrench to loosen two screws on knob (34).
34
ti13207a
5.Remove gasket (115), nut and potentiometer (82) from control panel (68).
| 68 |
82 | 82 |
| |
115 | ti13674a |
|
Installation
1.Install gasket (115), nut and potentiometer (82) on control panel (68). Torque nut to
68
82
82
115
ti13674a
2.Rotate new potentiometer shaft to highest pressure setting (fully clockwise) and install knob (34). Use allen wrench to tighten two screws on knob.
34
ti13338a
3.Connect potentiometer connector (C) to motor con- trol board.
95
C
ti12997a
4.Install control panel and tighten two screws.
5.Install cover (96) with four screws (38).
96
38
ti13493a
24 | 3A0157A |
