G0621 Wood/Metal Bandsaw -11-
After all parts have been removed from the two
boxes, you should have the following items:
Main Components: (Figure 2) Qty
A. Bandsaw Unit .............................................1
B. 6" Handwheel .............................................1
C. Handwheel Handle .....................................1
D. Miter Gauge ................................................1
E. Table .......................................................... 1
F. Scale .......................................................... 1
G. Table Insert ................................................1
H. Stand Door Knob 5⁄16"-18 x 1" .....................1
I. Dust Port 21⁄2" .............................................1
J. Table Trunnion Knobs 3⁄8"-16 .....................2
K. Rear Rail ....................................................1
L. Front Rail ....................................................1
M. Front Rail L-Brackets .................................2
N. L-Bracket Knobs 5⁄16"-18 x 5⁄8" .....................2
O. Fence Assembly .........................................1
P. Stand Assembly ......................................... 1
Fasteners and Tools: (not shown) Qty
• Rubber Feet (Stand) ..................................4
• Hex Bolts 5⁄16"-18 x 1" (Feet) ......................4
• Flat Washers 5⁄16" (Feet) .............................4
• Hex Nuts 5⁄16"-18 (Feet) ..............................4
• Hex Bolts 5⁄16"-18 x 3" (Stand/Bandsaw) ....4
• Flat Washers 5⁄16" (Stand/Bandsaw) ...........8
• Hex Nuts 5⁄16"-18 (Stand/Bandsaw) ............4
• Hex Bolt 3⁄8"-16 x 31⁄2" (Positive Stop) ........ 1
• Hex Nut 3⁄8"-16 (Positive Stop) ...................1
• Cap Screws M6-1 x 16 (Front Rail) ........... 2
• Front Rail T-Slot Nuts (Front Rail) .............2
• Cap Screws M6-1 x 16 (Rear Rail) ............2
• Guide Blocks (Blade Guides) .....................4
• Thumbscrews 1⁄4"-20 x 1⁄2" (Blade Guides) .4
• Phlp Hd Screws 10-24 x 1⁄4" (Dust Port) .....4
• Hex Wrenches 3, 5, 8mm ................. 1 each
• Flat Wrench 12/14mm ................................1
If any nonproprietar y par ts are missing (e.g. a
nut or a washer), we will gladly replace them, or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
Some hardware/ fasteners on th e inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss-
ing.
Inventory A
BCDEF
J
I
P
Figure 2. Main components inventory.
K
G
H
M
L
N
O