10.Place the table insert in the center of the table, so it sits flush with the table top sur- face.

11.Insert the pin into the end of the table slot.

12.Attach the rail brackets to the front of the table with the two M6-1 x 16 cap screws, as shown in Figure 9.

Rail Brackets

Figure 9. Rail brackets attached to table.

13.Slide the front rail nuts into the T-slot on the underside of the front rail.

14.Fasten the front fence rail to the rail brackets with the two rail bracket knobs, as shown in Figure 10, going into the front rail nuts.

Figure 10. Fastening front fence rail.

G0621 Wood/Metal Bandsaw

15.Fasten the rear fence rail to the back of the bandsaw with two M6-1 x 16 cap screws, as shown in Figure 11.

Rear Rail

Table Pin

Figure 11. Rear fence rail attached to table.

16.Pull the fence handle up and place the fence on the front fence rail, as shown in Figure 12.

Figure 12. Installing fence onto rails.

17.Push the fence handle down to lock the fence in position.

-15-

Page 17
Image 17
Grizzly G0621 owner manual