Grizzly G0621 owner manual Assembly, To assemble the bandsaw

Assembly

To assemble the bandsaw:

1.Install the rubber feet into the bottom of the cabinet stand, as shown in Figure 5, with the four 5⁄16"-18 x 1" hex bolts, four 5⁄16" flat wash- ers, and four 5⁄16"-18 hex nuts.

��������

����

����

������

�������

Figure 5. Rubber foot order of installation.

The bandsaw is heavy and awkward to lift. Use a forklift or other powered lifting aid.

2.Using a forklift or other powered lifting aid, place the bandsaw on top of the stand.

3.Align the mounting holes on the bandsaw base with those in the stand.

4.Secure the bandsaw to the stand with the four 5⁄16"-18 x 3" hex bolts, eight 5⁄16 flat wash- ers, and four 5⁄16"-18 hex nuts (Figure 6).

Figure 6. Bandsaw mounted to stand.

-14-

5.Thread a 3⁄8"-16 hex nut half way up the posi- tive stop bolt (Hex Bolt 3⁄8"-16 x 31⁄2").

6.Thread the positive stop bolt into the trunnion base so it is installed as shown in Figure 7.

Positive

Stop

Bolt

Figure 7. Positive stop bolt installed.

7.Remove the table pin from the table.

8.Fit the table around the blade and rest the table trunnions on the trunnion base, making sure the trunnion bolts extend through the bottom of the trunnion base.

9.Thread the two table trunnion knobs onto the trunnion bolts, as illustrated in Figure 8.

�����

��������������

�������������

�������������

�������������

Figure 8. Table installation on trunnion base.

G0621 Wood/Metal Bandsaw