Spindle Break-In

It is essential to closely follow the proper break-in procedures to ensure trouble-free performance of your mill.

NOTICE

DO NOT leave the area while the break- in procedure is under way. You must be ready to stop the machine if any problem occurs.

NOTICE

Successfully complete the spindle break-in procedure to avoid rapid wear of spindle components when placed into operation.

-18-

To perform the spindle break-in procedure:

1.Turn the machine ON, then use the speed dial to adjust the spindle speed to approxi- mately 200 RPM.

2.Let the mill run at this speed for 20 minutes, then turn the spindle OFF and wait for it to stop.

3.Use the spindle direction switch on the con- trol panel to reverse the spindle direction, then turn the mill ON and let it run for another 20 minutes.

4.Set the spindle speed at approximately 1800 RPM, repeat Steps 2–3,then proceed to

Step 5.

5.Turn the mill OFF. The spindle break-in is now complete and the machine is ready for operation.

Model G0695 (Mfg. Since 9/10)

Page 20
Image 20
Grizzly G0695 owner manual Spindle Break-In, Step