Headstock Ram

Movement

The headstock can be moved inward or outward along the ram.

Always lock the ram firmly in place after adjusting its position. If the headstock slips during milling operation, the spinning cutter could bind and break apart, causing serious personal injury or property damage.

Tools Needed

Qty

Hex Wrench 8mm

1

To move the ram inward or outward:

 

1.DISCONNECT MILL FROM POWER!

2.Loosen the three recessed cap screws, then tighten the two raised cap screws slightly to expand the clamp (see Figure 28).

Model G0695 (Mfg. Since 9/10)

Raised Cap Screws

Ram

Recessed Cap

 

Screws

Clamp

 

Figure 28. Location of cap screws for adjusting

ram movement.

3.Push or pull the headstock in the direction of desired ram movement.

4.Loosen the two raised cap screws to allow the clamp to close, then tighten the three recessed cap screws to tighten the clamp around the headstock tube.

-27-

Page 29
Image 29
Grizzly G0695 owner manual Headstock Ram Movement, To move the ram inward or outward