Adjusting Backlash

 

V-Belt Replacement

 

 

 

 

 

 

Leadscrew backlash is the amount of motion the leadscrew rotates before the device begins to move. Leadscrews always have a certain amount of backlash that will increase with wear. Generally, 0.005"–0.010" of backlash is acceptable.

The backlash of the longitudinal and cross leadscrew can be adjusted by changing the gap in the leadscrew nuts (see Figures 63–64).

Gap

Longitudinal

Leadscrew Nut Cap

Screws

Figure 63. Longitudinal leadscrew nut.

Cross

Leadscrew Nut

Gap

Cap

Screw

Figure 64. Cross leadscrew nut.

Use a 5mm hex wrench to tighten or loosen the cap screws on the leadscrew nuts shown in Figures 63–64, then test the amount of backlash by slowly rocking the handwheels back-and-forth.

If the belt is cracked, frayed, or shows signs of slipping and glazing you must replace it.

Tools Needed

Qty

Wrench 17mm

1

Hex Wrench 5mm

1

To replace the V-belt:

 

1.DISCONNECT MILL FROM POWER!

2.Get an assistant's help, and tilt the head- stock to approximately 90 degrees (Figure 65), then tighten the headstock tilt lock nuts to hold the headstock in place.

Figure 65. Headstock tilted to 90 degrees.

3.Using a Phillips screwdriver, remove one of the belt access plates.

Model G0695 (Mfg. Since 9/10)

-41-

Page 43
Image 43
Grizzly G0695 owner manual Adjusting Backlash Belt Replacement, To replace the V-belt