Joining Drill Chuck
& Arbor
An arbor is included for the drill chuck that comes with this machine. The following procedure describes how to install the arbor in the chuck.
After the arbor is installed in the drill chuck, it is very difficult to separate the assembly. If you would like to use a different chuck in the future, we recommend obtaining a new arbor.
Important: DO NOT install the drill chuck and arbor assembly into the spindle until AFTER the test run.
To join the drill chuck and arbor:
1.Use acetone or lacquer thinner to clean drill chuck and arbor mating surfaces, especially the bore.
2.Retract chuck jaws completely into chuck.
3.Insert small end of arbor into chuck.
4.Hold assembly by the arbor and tap chuck onto a block of wood with medium force, as illustrated in Figure 8.
Figure 8. Tapping drill chuck/arbor on block of
wood.
5.Attempt to separate drill chuck and arbor by hand—if they separate, repeat Steps 3–4.
Lubricating Mill/Drill
GEARBOX MUST
BE FILLED WITH OIL!
OIL MAY NOT BE
SHIPPED WITH MACHINE!
Refer to Lubrication Section
for Correct Oil Type.
The headstock oil reservoir must be properly filled with oil before the mill/drill can be operated for the first time.
Damage caused by running the mill/drill without the proper amount of oil in the reservoir will not be covered under warranty. Refer to the Lubrication section, beginning on Page 30, for details on how to check and add oil.
Model G0755 (Mfg. Since 1/13)
