Grizzly G0755 owner manual Installing/Removing Tooling, Installing Tool Holder, Tool Needed Qty

Installing/Removing

Tooling

The Model G0755 includes the following spindle tools (see Figure 24):

A.b16 Drill Chuck w/R-8 Arbor: Use with drill bits.

B.R-8–MT#3 Spindle Sleeve: Use with MT#3 tooling with or without a tang. Has a drift key slot for tool removal.

C.MT#3–MT#2 Spindle Sleeve: Use with the R-8–MT#3 spindle sleeve for MT#2 tooling. Has a drift key slot for tool removal.

Alignment Slot
	Drift Key Slot

		C
A
	B

Figure 24. Drill chuck and arbors included with

Model G0755.

Cutting tools are sharp and can easily cause laceration injuries. Always protect your hands with leather gloves or shop rags when handling cutting tools.

-24-

Installing Tool Holder
Tool Needed	Qty
Wrench 19mm	1

To install tool holder:

1.disCONNECT MACHINE FROM POWER!

2.remove drawbar cap as shown in Figure 25.

Drawbar
Drawbar Cap	Adjustment
	Nut

Figure 25. Drawbar components.

3.Align tool holder alignment slot (see Figure 24) with pin inside spindle, then insert tool holder into spindle until it contacts drawbar.

Note: Drawbar height inside spindle can be changed by rotating the adjustment nut (see Figure 25).

4.Working from the top, hand-thread drawbar into tool holder until snug, then use a 19mm wrench to tighten it.

Note: DO NOT overtighten drawbar. Overtightening makes tool holder removal difficult and could damage arbor and drawbar threads.

5.re-install drawbar cap.

Model G0755 (Mfg. Since 1/13)