Grizzly G0756 owner manual Test Coolant System, To test the coolant system

Test Coolant System

This drill press comes with a pump-driven cycling coolant system. Prior to testing the coolant sys- tem, add two gallons of coolant to the coolant res- ervoir. Refer to Changing Coolant on Page 28.

To test the coolant system:

1. Wear safety goggles and other protective clothing.

2. Aim the coolant nozzle into the trough to reduce splash (see Figure 13).

	Coolant Drain
Table trough

Figure 13. Table trough and coolant drain.

-20-

3. turn the Coolant Pump Switch to the ON position.

4. Adjust the ball valve in the coolant nozzle assembly for the proper coolant flow (see Figure 14).

Ball valve

Figure 14. Ball valve of nozzle assembly.

5. Close the ball valve and turn the pump switch to the OFF position.

Running the pump without adequate cool- ant can significantly damage the pump, which will not be covered under warranty.

Model G0756 (Mfg. Since 2/13)