Depth Stop
This drill press includes a depth stop for drilling multiple holes at the same depth.
To set the depth stop:
1.DISCONNECT MACHINE FROM POWER!
2.Adjust the table height so the workpiece is close to the work tool.
3.Mark the side of your workpiece at the intend- ed cutting depth (see Figure 19).
Workpiece
Drill Bit
Scrap Wood
Workpiece
Depth
Mark
Table
Figure 19. Depth stop mark on workpiece.
4. Secure the workpiece to the table with a clamp or vise.
5.Place the workpiece on the table, and lower the spindle until the tip of the bit is even with the mark.
6.Loosen the depth stop handle, move the drill bit to the required drilling depth, and tighten it (see Figure 20).
Depth Stop Handle
Figure 20. Setting depth stop handle.
7. Press the spindle start button.
8.Drill a hole into scrap stock before drilling into any workpiece to ensure the depth has been set correctly. If necessary, repeat Steps 2–5.
Table Positioning
The table for this drill press moves vertically and rotates 360 degrees to accommodate larger workpieces.
Raising/Lowering Table
1. Remove any objects from the table surface.
2. Loosen the release handles shown in Figure
21).
3. Adjust the table height by rotating the height adjustment handle (see Figure 21).
Height
Adjustment
Handle
Lock Handles
Figure 21. Column Release and Height
Adjustment Handles.
Rotating Table
1. Remove all objects from the table surface.
2. Slightly loosen the lock handles (see Figure
21).
3. Push the table to the desired location, and guide the rack on the side of the column.
4.
Model G0756 (Mfg. Since 2/13)
