Grizzly Model G1022proz instruction manual Handwheels, All Models, To mount the handwheels

All Models:

8.Place the assembled stand upside down on the table saw body and align all the mounting holes. Make certain the side of the stand with the “Z Series” label, if applicable, is on the front side of the machine (the side with the Grizzly label and angle scale).

9.Secure the stand to the body using M8-1.25 x 19 hex bolts, 8MM flat washers and M8- 1.25 hex nuts, with the dust port sandwiched between on the Models ZF, ZFX, PROZ, & PROZX, as shown in Figure 13.

Saw Body
Dust Hood Adapter
(ZF, ZFX, PROZ, &	Dust Hood
PROZX Only)
	(ZF, ZFX, PROZ,
	& PROZX Only)
Stand

Figure 13. Attaching the stand to the saw base.

The Model G1022 Series is a heavy machine, weighing up to 340 lbs. Personal injury could occur if the machine is moved without addition- al assistance. Seek the assistance of other peo- ple when moving or lift- ing the machine.

10.With the help of a second person, flip the entire table saw unit right side-up and move it into its working position.

11.Tighten all of the stand bolts.

Handwheels

To mount the handwheels:

1.Position one of the handwheels over the arbor lifting shaft on the front of the saw.

2.The slots in the handwheel hole will engage with the roll pin on the shaft as shown in Figure 14.

3.Position the other handwheel on the blade tilting shaft located on the side of the saw.

4.Screw the black plastic lock knobs onto the ends of the shafts to lock the handwheels in place.

Roll Pin

Body mounted switch on

Models SM & Z only

Figure 14. Mounting the handwheels.

G1022 Series Table Saws -21-