Fence Rails
NOTICE
The Models SM & Z are supplied with round rails, the Models ZF, ZFX, & PROZX are supplied with flat angular bar sections and the Model PROZ is supplied with square tube rails. This accommodates the standard fence for the Models SM & Z, the SHOP FOX®
To mount the rails (Models SM & Z):
The two center bolts for each rail thread directly into the table top, and the outer two bolts secure from the back side of the extension wing with hex nuts.
Place a spacer on each bolt between the rail and the table/wing edge as shown in Figure 24. Be sure that the rail with the
Figure 24. Attaching fence rails.
Fence
NOTICE
The Models ZX, ZXF, PROZ, & PROZX use a SHOP FOX® brand fence. Please refer to the manual included with the SHOP FOX® fence for adjusting instructions.
The fence must engage and square up on the front rail before the rear clamp engages the back rail. In essence, the rear clamp should act as a secondary mechanism for maintaining fence position. When adjusted correctly, the lever lock should only begin to apply pressure on the back rail over the last
To install and adjust the Model SM fence:
1.Thread the plastic knob onto the lock handle.
2.Slide the fence onto the rails.
3.Make sure the front clamp engages the front rail with the lock handle at
4.If the front clamp requires adjustment, loosen the check nut shown in Figure 25. Turn the adjusting bolt clockwise if the front clamp is too far from the rail, or counter- clockwise if it is too close.
Adjusting Bolt
Check Nut
Figure 25. Adjusting clamp mechanism.
G1022 Series Table Saws |
