Beginning Assembly |
| Stand Assembly |
|
|
|
|
|
|
Loose hair and clothing could get caught in machinery causing seri- ous personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.
Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly.
!Disconnect the machine
power cord during assembly. Failure to fol- low this warning could result in serious person- al injury or death.
TOOLS REQUIRED: High quality square and straightedge, metric Allen wrench set, flat screw- driver, Phillips screwdriver, dead blow hammer and a 6" or 8" adjustable wrench.
Examine the edges of all metal parts before han- dling. Sharp edges on metal parts may cause personal injury.
To assemble the stand:
1.Fasten the rubber feet to the leg bottoms using
Figure 9. Installing the rubber feet.
2.Bolt the long upper and lower side braces (2 each) to the legs using M8-1.25 x 16 car- riage bolts, 8MM flat washers and M8-1.25 hex nuts as shown in Figure 10. Do not com- pletely tighten the hex bolts at this time.
G1022 Series Table Saws |
