45˚ & 90˚ Stops
The Model G1022 Series Table Saws are equipped with positive stops at 45¡ and 90¡. When properly adjusted, they provide precise and dependable guides for bevel adjustment.
Use caution and remain alert when working around the saw blade. Failure to follow this warning could result in serious personal injury or death.
To set the 45˚ & 90˚ stops:
1.Disconnect the machine from the power source!!
2.Raise the saw blade to its maximum height by turning the front handwheel clockwise.
3.Adjust the blade to the 90û position.
!
Figure 65. Checking blade angle to table.
5.With the square in place, inspect for gaps along the blade and square.
6.If a gap exists at either the top or the bottom of the square, loosen lock nut (A) and adjust- ment bolt (B) shown in Figure 66.
B 
A
C
D
Figure 66. 90¡ and 45¡ stop bolt adjustments.
7.Turn the handwheel until the blade and square are flush from top to bottom.
8.Snug the adjustment screw and tighten the lock nut.
9.Recheck the blade with the square to ensure the screw has not been over-tightened.
10.Using the side handwheel, adjust the blade bevel until you hit the 45¡ positive stop. Check the bevel with an adjustable square set to 45û.
11.If variations exist, loosen the lock nut (C) and adjust the stop bolt (D) (Figure 66) until your blade and square match.
12.Tighten the lock nut and recheck the bevel by adjusting the blade back to 90¡, then back to 45¡.
G1022 Series Table Saws |
