Lubrication
The sealed ball bearings in the motor and throughout the Model G1022 require no mainte- nance during their lifetime. When they do wear out, replacements can be obtained through the Grizzly Parts Department.
Lubricate the areas indicated below every 12 months:
BLADE ANGLING TRUNNIONÑThe front and back trunnions each have a
BLADE HEIGHT TRUNNIONÑThe blade height trunnion pivots on a steel rod. This should be lubricated with 6 or 7 drops of light machine oil.
WORM GEARS (Figure 58)ÑThese should be lubricated with an automotive wheel bearing grease.
Lubrication Points
Figure 58. Worn gear lubrication points.
Table
The table is made from cast iron. If preventative measures are not taken, the table surface will rust. Regularly wipe sawdust from the table to prevent rust causing moisture from becoming trapped against the table. Regular applications of products like SLIPIT¨ will prevent rust as the saw is used on a daily basis. For long term storage, use products such as Boeshield T-9¨. Both of these products are available in the Grizzly catalog.
V-Belt
Inspect the
|
|
|
|
|
|
|
|
|
|
|
|
G1022 Series Table Saws | |||
