Grizzly Model G1022proz instruction manual Proper Alignment Added Washers

9.Next, set a straightedge against the face of the saw blade and the blade guard/splitter as shown in Figure 39. If the blade guard/split- ter is properly aligned, please skip ahead to the next section; otherwise, continue with the next step.

!

Figure 39. Checking alignment of blade guard.

10.If the blade guard/splitter is to the right of the blade as shown in Figure 40, add washers between the splitter and front mounting bracket and adjust the rear splitter support as shown in Figure 40.

Adjust here

to move back of splitter left or right.

Splitter	Add washers
	here to move
	front of split-
	ter to the left.

Blade

Figure 40. Improper splitter/blade alignment.

-32-

11.Recheck guard alignment to the blade and to the table top. Adjust as necessary and tight- en all the bolts before use. If the blade guard is properly aligned, please skip ahead to the next section; otherwise, continue with the next step.

12.If the splitter is positioned to the left of the blade, alignment cannot be achieved by washer placement. Adjustment of the front support bracket is required as shown in Figure 41. Loosen the adjustment screws and move the front support bracket to the right.

	Adjusted
	Rear Splitter
	Adjustment
	Screw
	Front Support
	Bracket
Proper Alignment	Added Washers

Figure 41. Proper splitter/blade alignment.

13.Recheck guard alignment to the blade and to the table top. Adjust as necessary and tight- en down all the bolts before use.

14.Adjust the blade to 45¡ and raise and lower it through the full range. Re-adjust blade to 90¡ and raise and lower it through the full range. There should be no contact between the base and the table insert or any other part of the saw. If there is, repeat Steps 1- 13.

G1022 Series Table Saws