Harman-Kardon WMS 470 manual Optional RMS 4000 Remote Mute Switch

4 Setting Up

Optional RMS 4000 Remote Mute Switch

The optional RMS 4000 Remote Mute Switch allows you to mute the transmitter if it is mounted in a position where it is difficult or impossible to use the "on-board" MUTE switch.

1.Plug the cable (1) on the Remote Mute Switch into the REMOTE MUTE jack (2) on the transmitter.

2.Put the Remote Mute Switch in a jacket or shirt pocket or use the belt clip to clamp the Remote Mute Switch on the belt.

3.To mute the microphone, press the button on the Remote Mute Switch. The button will lock and the status LED will change to red.

4.To switch the microphone back on, press the button again. The status LED will change to green.

Refer to fig. 16 on page vi.

Setting Input Gain

1.Switch power to the receiver on.

2.Set the ON-MUTE/PRG-OFF switch (19) to "MUTE/PRG". The display will alternately in- dicate the currently selected frequency and "PRG IR".

3.Call up the "HT GAIN" menu on the receiver and select "HI" or "LO" (vocal use).

4.Point the infrared sensor (1) on the transmitter at the infrared emitter (2) on the receiver from a distance of 4 inches (10 cm) max. to activate the selected gain setting.

SILENT Mode

We recommend setting the carrier frequency in SILENT mode only (radio transmission OFF) only.

•To engage SILENT mode, push the ON/OFF switch to "OFF" and then to its center posi- tion. This is the only way to make sure you won't go "on air" on a frequency that is not allocated or coordinated and risk "jamming" or interfering with some other RF device or wireless system.

Selecting Battery Type

1.Switch power to the receiver on.

2.Set the ON-MUTE/PRG-OFF switch (19) to "MUTE/PRG". The display will alternately in- dicate the currently selected frequency and "PRG IR".

3.In the "BAT.TYP" menu, select the battery type you inserted: "LR6", "FR6", "HR6 (for NiMH rechargeable batteries) or "AUTO".

In "AUTO" mode, the transmitter automatically identifies the battery type.

4.Point the infrared sensor (1) on the transmitter at the infrared emitter (2) on the receiver from a distance of 4 inches (10 cm) max. to activate the selected mode.

WMS 470

Handheld Transmitter Refer to fig. 10 on page vi.

Referto fig. 4 on page iv. Refer to fig. 3 on page v.

Refer to figs. 10 and 11 on page vi.

Handheld and Bodypack Transmitters

Referto fig. 4 on page iv. Refer to fig. 3 on page v.

Refer to figs. 10 and 11 on page vi.

35