Healthrider WESY8630C3 manual 3/8 x 5 Bolt 74 and the 3/8 Nylon Locknut, Post

CABLE ASSEMBLY

40. Note: The 3 1/2” Pulley (82) used in this			40
step was attached in step 38. It is shown
removed for easier part identification.
Route the Press Cable (88) around the 3 1/2”
Pulley (82). Be sure that the Cable Trap (80)					9	42
is turned to hold the Cable in place and
that the Cable is routed as shown.		Tighten				82
the 3/8” x 5” Bolt (74) and the 3/8” Nylon						80
Locknut (42).
						88
					74
41. Slide a 5/16” Washer (20) onto a 5/16” x 2 3/4”			41
Bolt (55). Insert the Bolt into the Front Seat
Frame (8). Fully tighten a 5/16” Nylon Jam
Nut (91) onto the Bolt. Slide the end of the
Press Cable (88) onto the Bolt. Thread anoth-
er 5/16” Nylon Jam Nut onto the Bolt,		but do
not fully tighten it. Leave enough room						88
between the two Jam Nuts for the Cable to					8
pivot.
						91
			55		20
42. Identify the High Cable (85)—this is the			42
shortest remaining cable.	Wrap the	High
Cable around a 3 1/2” Pulley (82). Attach the
Pulley to the Top Frame (2) with a 3/8” x 3 3/4”
Bolt (76), a 3/8” Washer (38), and a 3/8”				2
Nylon Locknut (42).	Be sure that the end of		38
the Cable with the ball is on the indicated
			42
side of the Pulley and that the Cable is
between the Pulley and the post.					82
			Post
			85		76
43. Wrap the High Cable (85) around a 3 1/2”			43
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the Top Frame (2) with a 3/8” x				76
3 3/4” Bolt (76), a 3/8” Washer (38), and a					38
3/8” Nylon Jam Nut (43).	Be sure that the
Cable Trap is positioned to hold the Cable				2	80
in place.
					82	43
					85
			17