Healthrider WESY8630C3 Pulley Plates 31 and 3 1/2 Pulleys, Groove of the Pulley, But, Pivot

CABLE ASSEMBLY

21. Wrap the Butterfly Cable (89) around a 3 1/2”		21
Pulley (82) as shown. Attach the Pulley and a
Cable Trap (80) to the bracket on the Leg					42
Press Upright (4) with a 3/8” x 2” Bolt (50)
					4
and a 3/8” Nylon Locknut (42).	The Cable			82
Trap must be oriented as shown and be
positioned to hold the Cable in the groove
of the Pulley.				50
				80
				89
22. Locate one of the preassembled pairs of		22
Pulley Plates (31) and 3 1/2” Pulleys (82).
Route the Butterfly Cable (89) under the indi-
cated 3 1/2” Pulley (82). The end of the Pulley			89
Plates (31) with two holes should be down-					89
	Be sure
ward. Refer to the inset drawing.
that the Cable is between the Cable Trap
(80) and the Pulley, and that the Cable Trap		82
is positioned to hold the Cable in place.				50
					80
Tighten the 3/8” x 2” Bolt (50) and the 3/8”				End with
				two holes
Nylon Locknut (not shown).		31
				should be
				down
23. Wrap the Butterfly Cable (89) around a 3 1/2”		23
Pulley (82) as shown. Attach the Pulley and a
				80
Cable Trap (80) to the other side of the bracket					50
on the Leg Press Upright (4) with a 3/8” x 2”
Bolt (50) and a 3/8” Nylon Locknut (42).		The		42
Cable Trap must be oriented as shown and					89
				82
be positioned to hold the Cable in the
groove of the Pulley.				4
24. Note: The Left Fly Arm (6) is shown		24
removed for easier part identification.
Insert a 5/16” x 1” Bolt (51) through the brack-				91
et on the Left Fly Arm. Fully tighten a 5/16”
Nylon Jam Nut (91) onto the Bolt.			89
Slide the free end of the Butterfly Cable (89)
onto the 5/16” x 1” Bolt (51). Thread another
5/16” Nylon Jam Nut (91) onto the Bolt,		but			6
do not fully tighten it. Leave enough room			51
between the two Jam Nuts for the Cable to
pivot.

12