Hearth and Home Technologies CFX-Crescent owner manual Removing Glass Door, Installing the Trim

Step 10

Glass Door

Removal,

Installing Trim,

Handle, Logs

and Ember

Material

Removing Glass Door

Remove the glass assembly. Using a phillips screw driver, loosen the top two screws. Unfasten the bottom retention clips and pull glass assembly out from the bottom. See Figure 28.

TOP TWO

SCREWS

GLASS

ASSEMBLY

BOTTOM

RETENTION

CLIPS

	Figure 28. Glass Door Removal
	Installing the Trim
	Combustible materials may be brought up to the
	specified clearances on the side and the top front edges
	of the fireplace, but MUST NEVER overlap onto the
	front face. The joints between the finished wall and the
	fireplace top and sides can only be sealed with a 300° F.
	(149° C) minimum sealant.
	Install optional marble and brass trim surround kits as
	desired. Marble, brass, brick, tile, or other non-
	combustible materials can be used to cover up the gap
	between the sheet rock and the fireplace. They can
	overlap front face up to arch door front.
	When overlapping on both sides, leave enough space
	so the decorative door is accessible.
CAUTION	NON-COMBUSTIBLE FINISHING MATERIALS
	MUST NEVER COVER/OVERLAP ARCHED
	DECORATION DOOR.

Heat & Glo • CFX-CRESCENT • 705-900 Rev. P • 12/07 33