Hearth and Home Technologies 6000TRSI-AUC, Heat & Glo manual Operating Cautions

FLAME SPARKER/
SENSOR	VALVE
	REMOTE
	CONTROL
	ANT.
	ON/OFF
PILOT	WALL SWITCH
	IGNITION
IGNITION MODULE	MODULE
	(6V)
6VDC
	GROUND
NEUTRAL	HOT
BATTERY PORT
	PLUG IN
ON/OFF	THERMOCOUPLE
	BLOCK
SWITCH	(CONNECTED TO
	BACK OF VALVE)
	VALVE
GAS LINE
CONNECTED TO
BACK OF VALVE
FIGURE 2.1

OPERATING CAUTIONS

•THIS APPLIANCE MAY EXHIBIT A SLIGHT CAR- BON DEPOSITION.

•DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.

•DO NOT USE OR STORE FLAMMABLE MATERI- ALS NEAR THIS APPLIANCE.

•DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.

•THE DRESS GUARD IS FITTED TO THIS APPLI- ANCE TO REDUCE THE RISK OF FIRE OR INJURY FROM BURNS AND NO PART OF IT SHOULD BE PERMANENTLY REMOVED. FOR PROTECTION OF YOUNG CHILDREN OR THE INFIRM, A SEC- ONDARY GUARD IS REQUIRED.

•THE DRESS GUARD MUST BE IN PLACE AND SEALED AND THE FIXED MESH TRIM ASSEM- BLY MUST BE IN PLACE ON THE HEATER BE- FORE THE UNIT CAN BE PLACED INTO SAFE OP- ERATION.

•DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. IMMEDIATELY CALL A QUALIFIED SERVICE TECHNICIAN TO INSPECT THE UNIT AND TO REPLACE ANY PART OF THE CONTROL SYSTEM AND ANY GAS CONTROL WHICH HAS BEEN UNDERWATER.

•DO NOT OPERATE THIS APPLIANCE WITH THE GLASS DOOR REMOVED, CRACKED, OR BRO- KEN. REPLACEMENT OF THE GLASS DOOR SHOULD BE DONE BY A LICENSED OR QUALI- FIED PERSON. DO NOT STRIKE OR SLAM THE GLASS DOOR.

•THE GLASS DOOR ASSEMBLY SHALL ONLY BE REPLACED AS A COMPLETE UNIT AS SUPPLIED BYTHE GAS HEATER MANUFACTURER. NO SUB- STITUTE MATERIALS MAY BE USED.

Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. G • 12/06 25