Heat & Glo LifeStyle BAY-40 7 Installing an ST1175 Square Termination Cap, Cap Base bracket screw

•For installations utilizing an ST1175 Square Termination Cap the last chimney section must not be more than 4-1/2 in. (114 mm) below the chase top. See Figure 6.7.

		Flashing Collar
Cap Standoff			2 in. (51 mm) min.
					4-1/2 in.
1-1/2 in.
(38 mm) min.				(114 mm)
overlap	Top of Pipe					max.

•For chase installations you can use a TR11 Round Termination Cap, a TR11T Round Telescoping Termination Cap, an ST1175 Square Termination Cap, or a TCT1175 Terra Cotta Termination Cap.

•For installations utilizing a European Copper Series Termination Cap, See Figure 6.9.

•Install termination caps following instructions provided with them.

Figure 6.7 Installing an ST1175 Square Termination Cap

•For installations utilizing an TCT1175 Terra Cotta Cap the last chimney section must be between 7 in. (178 mm) below the chase top and 2 in. (51 mm) above. See Figure 6.8.

Cap Base

bracket (8)

screw (8)*

(cap inner flue)

1-1/2 in. (38 mm) min. overlap

{

The last section of pipe must stop between the distances given below.

2 in. (51 mm) above top of the chase.

chimney top

chase top

(metal or masonry) SL pipe inner flue

2 - 6 in. (51-152 mm)

2 in. (51 mm) typical

Top of Pipe

7 in. (178 mm) below top

of the chase.

Figure 6.9 Installing a European Copper Series Termination Cap (CT3-King shown)

Figure 6.8 Installing a TCT1175 Terra Cotta Cap

Heat & Glo • Multi-Sided Woodburning Fireplace • 34977 Rev T • 11/07 25