J.Installation Instructions and Venting In- formation - PVK-80 for RED60 Model

These instructions are for appliances utilizing the PVK-80 for the RED60 model. For appliances incorporating the PVI-DVP. See Section 7.F.

PVK-80 POWERVENT

Figure 7.30 PVK-80 Power Vent

IMPORTANT NOTE: When installing the PVK-80 with the RED60 model, these PVK-80 installation instructions su- percede the instructions that are included with the PVK- 80 Power Vent Kit.

WARNING! Risk of Fire! Failure to follow these instruc- tions may create a fire hazard and may void the fireplace warranty. Install PVK-80 on RED60 model per these in-

structions.

THESE INSTRUCTIONS MUST REMAIN WITH THE EQUIPMENT.

INTRODUCTION

The PVK-80 Power Vent can be used on RED60 direct vent gas fireplaces manufactured by Hearth & Home Technologies.

The PVK-80 Power Vent operates on 120VAC, 60Hz electrical service.

Components and Service Parts List

Service Parts List

Replacement parts can be obtained from your dealer. Re- pair of the Power Vent should only be done by a qualified service technician. A list of replacement parts is shown in the service parts section of this manual.

6.CLEARANCES BETWEEN THE VENT PIPE AND COMBUSTIBLE MATERIALS MUST BE MAIN- TAINED AT 3-INCH TOP, 1-INCH SIDES, AND 1-INCH BOTTOM.

7.CAUTION: Failure to install, operate, and maintain the power venting systemin accordance with manufacturer's instructions will result in conditions which may produce bodily injury and/or property damage.

NOTICE: The blower motor present in this appliance will generate sound during operation. The effects of the increased sound level can be minimized with careful planning during installation of the system.

INSTALLATION OF PVK-80

POWER VENT

1.Location of venting system terminations must be made in accordance with national, provincial, and/or local codes. The minimum clearance requirements must be followed on models using the PVK-80 Power Vent.

A.The exit termination of mechanical draft systems shall not be less than 7 feet above grade when located ad- jacent to public walkways and at least 10 feet from lot line or adjacent buildings.

B.A mechanical drafting venting system shall terminate at least 3 feet above any forced air inlet located within 10 feet.

C.The venting system of direct vent appliances shall ter- minate at least 12 inches below, 12 inches horizontally from, or 12 inches above any building opening through which flue gases could enter.

D.The vent termination point shall not be installed closer than 2 feet from an inside corner of an L-shaped struc- ture.

E.The vent termination should not be mounted directly above or within 3 feet horizontally from an oil tank vent or gas meter.

F.The bottom of the vent termination shall be located at least 2 feet above the finished graded and 2 feet above any combustible projection.

INSTALLATION PRECAUTIONS

1.

This device must be installed by a qualified installer in

 

accordance with these instructions.

2.

Safety inspection of the venting system should be

 

performed before and after installation of this power

 

vent. Consult local code officials and follow applicable

 

installation codes.

3.

DO NOT INSTALL DAMAGED EQUIPMENT OR VENT

 

COMPONENTS.

4.

Disconnect electrical power supply before making wiring

 

connections.

3 in. (76 mm) top clearance

1 in. (25 mm) clearance around vertical sections

Heat

Shield

Wall

Shield

Firestop

3 in. (76 mm) top clearance *

1 in. (25 mm) clearance bottom & sides

5. VENTING OF MORE THAN ONE APPLIANCE IN A

COMMON VENT SYSTEM IS PROHIBITED.

WALL

Figure 7.31

38

Heat & Glo • RED60 • 2159-900 Rev. R • 9/12

Page 38
Image 38
Heat & Glo LifeStyle RED60 2159-900 manual These Instructions Must Remain with the Equipment, Components

RED60 2159-900 specifications

The Heat & Glo LifeStyle RED60 2159-900 is a modern and innovative gas fireplace that exemplifies cutting-edge design and advanced heating technology. With its sleek aesthetics and smart features, this fireplace is designed to elevate both comfort and style in any living space.

One of the main features of the RED60 is its impressive heat output. This model boasts a high efficiency rating, ensuring that homeowners can enjoy warmth without excessive energy consumption. The fireplace can deliver an output of up to 60,000 BTUs, making it suitable for both large and small areas. This efficient performance means less environmental impact, aligning with the growing emphasis on sustainability in home heating solutions.

The design of the Heat & Glo LifeStyle RED60 is another standout aspect. Its expansive glass viewing area provides a panoramic view of the flames, creating a beautiful focal point in any room. The minimalist frame enhances the contemporary aesthetic, allowing it to seamlessly complement various interior styles, from modern chic to traditional elegance.

In terms of technology, the RED60 incorporates advanced combustion systems, ensuring cleaner emissions without sacrificing performance. This technology not only contributes to a healthier indoor environment but also helps reduce the carbon footprint associated with home heating. Additionally, the fireplace features a patented heat distribution system, which optimally circulates warmth throughout the space, eliminating cold spots and enhancing overall comfort.

The RED60 also offers convenience through its intuitive remote control system. Users can easily adjust the flame height, heat output, and even set timers, providing ultimate flexibility in managing their indoor climate. For those who prefer a more hands-on approach, manual controls are also available, making it user-friendly for everyone.

Moreover, the installation process is simplified with the unit's flexible venting options, which can accommodate various configurations to suit different homes. Whether designing for a new build or retrofitting an existing space, this versatility appeals to homeowners and builders alike.

In summary, the Heat & Glo LifeStyle RED60 2159-900 is a blend of style, efficiency, and advanced technology. Its high heat output, sleek design, and intuitive controls make it an excellent choice for anyone seeking to enhance their living environment with a modern gas fireplace.