Heat & Glo LifeStyle RED60 2159-900 Wiring the PVI-DVP, Screws, Wire Harness, PVI-DVP Connections

Figure 7.13

The optional mounting brackets may come in handy when mounting the PVI to a studded wall. See Figure 7.13.

Securing the PVI inside a floor joist can be easily done us- ing the side brackets. See figure 7.14. If the side brackets can’t be used, or additional support is needed, the optional mounting brackets can be used as shown in Figure 7.15 and Figure 7.16.

SCREWS

Figure 7.14

SCREWS

Figure 7.15

SCREWS

Figure 7.16

Wiring the PVI-DVP

NOTICE: Electrical wiring must be done in accordance with national, provincial, and/or local electric codes.

CAUTION: Risk of shock! Disconnect electrical power from fireplace/power vent before performing any mainte- nance, repair, or electrical wiring.

NOTICE: Electrical service of 120 VAC-60Hz must be supplied to the junction box of the fireplace in order for the power vent to operate correctly.

1. Wire Harness

a.Determine the length of the wire harness required to run between the PVI-DVP and the appliance from the service parts list.

b.On the end closest to the junction box, drill a 7/8 inch diameter hole and lead wire cable assembly through a Romex connector.

c.Attach the end of the harness with the loose wires to the PVI-DVP. Use supplied zip ties to contain all loose wiring. See Figure 7.18 and Figure 7.19.

d.Attach the end of the harness with the connector to the appliance.

2. PVI-DVP Connections

Refer to the PVI-DVP wiring diagram (Figure 12.5).

a.Attach the green wire from the harness to the quick ground connect. Connect the red wire to one of the spades on the vacuum switch. Connect the brown wire to the remaining spade on the vacuum switch.

b.Connect the white wire from the harness to the open female connector on harness, inside the PVI.

c.Connect the black wire from the harness to the open male connector on harness, inside the PVI.

3. RED60 Connections

Refer to the RED60 wiring diagram, Figure 7.17. Ensure wire harness has been fastened to the appliance. Route wires and wire harness in a manner that protects them from contact with sharp metal surfaces.

a.Attach the white, 3-wire connector to the AUX #2 con- nector on the AUX300.

b.Connect the brown wire to the brown wire coming from the 8K1-PVI.

c.Connect the red wire to the red wire coming from the 8K1-PVI.

Heat & Glo • RED60 • 2159-900 Rev. R • 9/12 27