Figure 4. Securing Tabs and Sheet Metal Screws.
|
Figure 5. Inner Front Base Pieces.
|
Figure 6. Inner Rear Base Pieces.
Figure 7. Outside Front Trim Base.
REAR BASE MESH GRANITE SUPPORT
FRONT BASE MESH GRANITE SUPPORT
Figure 8. Middle and Outer Base Pan Granite Support Tabs.
Installation
1.Ensure fireplace is turned off and glass is cool to the touch before beginning installation. .Remove back row and sides of 1/4 inch sheet metal screws from base pan as shown in Figure 9. The screws will be located either on top of or underneath the mesh. If underneath mesh, lift mesh screen up and remove for access to screw heads. Discard mesh.
2.Remove pilot shield as shown in Figure 10. Discard.
Figure 9. Removing Screws from Basepan.
3.Measure granite pieces to ensure you are installing them in the correct orientation. Install back panel pieces first. See Figure 11. These pieces are wider than they are tall. Install so the side measuring
PILOT
SHIELD
Figure 10. Removing Pilot Shield.
Heat & Glo • RED60 • | 79 |