Henny Penny 342 manual 2-16

Model OFE/OFG/OEA/OGA-341, 342

2-16.	BLOWER MOTOR
	REPLACEMENT
	(Continued)
		8. Using 3/8 inch nut driver, remove nuts securing blower to the
		unit. Figure 2-48. Pull blower from unit.
	Figure 2-48	9. Install new blower in reverse order.
2-17.	HEATING ELEMENTS
	(ELECTRIC)
		Heating elements are available for 208 and 230 voltage. Check
		data plate to determine correct voltage.
	Checkout	If the shortening temperature recovery is very slow or at a slower
		rate than required, this may indicate defective heating element(s).
		An ohmmeter quickly indicates if the elements are shorted or open.
		1. Remove electrical power supplied to the frypot to be checked
		To avoid electrical shock or property damage, move the
		power switch to OFF and disconnect main circuit
		breaker, or unplug cord at wall receptacle, to the frypot
	Figure 2-49	to be worked on. Be aware the other control on 2-frypot
		units will have power.

2.Remove rear cover. Figure 2-49.

3.Using a flat-head screwdriver, remove the appropriate wires from the terminal blocks. Figure 2-50.

Figure 2-50

106 2-17