Model OFE/OFG/OEA/OGA-341, 342

2-4. COMPLETE CONTROL Should the control board become inoperative, follow these PANEL REPLACEMENT instructions for replacing the board.

1. Remove electrical power supplied to the unit.

 

To avoid electrical shock or property damage, move the

 

power switch to OFF and disconnect main circuit

 

breaker, or unplug cord at wall receptacle.

Figure 2-9

2. Remove the two screws securing the control panel and lift out.

Figure 2-9.

3.Unplug the wire connectors going to the control panel. Figure 2-10.

4.Remove transformer(s) from control panel. They must be installed on the replacement panels.

5.Install new control panel in reverse order.

 

When plugging connectors onto new control panel, be sure the

 

connectors are inserted onto all of the pins, and that the

Figure 2-10

connectors are not forced onto the pins backwards. If not

connected properly, damage to the board could result.

2-5. POWER SWITCH

1. Remove electrical power supplied to fryer.

 

To avoid electrical shock or property damage, move the

 

power switch to OFF and disconnect main circuit

 

breaker, or unplug cord at wall receptacle.

2.

Remove control panel.

3. Label and remove wires from the switch. With test instrument

Figure 2-11

check across the terminals of the switch with switch in the on

 

position, and the circuit should be closed. In the off position,

 

the circuit should be open. If the switch checks defective,

 

replace by continuing with this procedure. Figure 2-11.

2-4

504

Page 4
Image 4
Henny Penny 342 manual Power Switch