Henny Penny BCC/BCR-175, BCC/BCR-140, BFR/BCR-350 manual Operating Controls, Description Function

Henny Penny			Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350
		SECTION 3. OPERATION
3-1. INTRODUCTION			This section provides operating procedures for the Blast Chiller.
			Sections 1, 2, and 3 should be read, and all instructions should be
			followed before operating the cabinet.
			This section contains an explanation of all controls and compo-
			nents and information on operating procedures and daily
			maintenance.
			If the blast chillers (that have compressors shipped with them)
			have been laid on its side, the unit must be sitting upright for at
			least an hour before applying power to the unit. Check all
			components for signs of being loose or damaged, and make
			sure the system has refrigerant. Failure to follow these
			instructions may cause damage to the components. Failure to
			follow these instructions could cause damage to the compres
			sor.
3-2. OPERATING CONTROLS			Pages 3-1 to 3-4 identifies and describes the function of all the
			operating controls.
Fig.	Item	Description	Function
No.	No.
3-1	1	On/Off Button	The On/Off button, when pressed, is a button on the
			control panel that starts a chilling cycle. It also must be
			pressed before any changes to the controls can be made,
			and to start and stop the De-ice cycle.
3-1	2	DigitalDisplay	The Digital Display shows the temperatures, the time
			(in a timing cycle), and the information in the technical
			mode.
3-1	3	Up and Down	The Up and Down Arrows are used when changing
		Arrows	times or settings.
3-1	4	Alarm Button	The Alarm button is used to stop the optional alarm buzzer
			and to enter the technical mode.
3-1	5	Temp Button	The Temp button is used to select either the chilling
		mode.
3-1	6	De-ice Button	The De-ice button is used to remove ice that may have
			formed on the evaporator during a chilling cycle.

3-1 100