Henny Penny OE-100 manual REPAIR Continued, Pump Removal, of the fryer, Filter Pump

Henny Penny	Model OE-100
2-16. FILTER PUMP	3. To reassemble, place rotor on drive shaft, and place rollers into
REPAIR (Continued)	rotor.
	NOTE
	A small amount of shortening might be needed to hold the
	bottom roller into place until cover plate is put on. Make sure
	O-ring is in proper position on plate.
2-17. PUMP REMOVAL	1. If the pump needs to be replaced, loosen one inch nuts from the
	outflow and inflow lines. Then remove the two bolts holding the
	pump to the motor with a 1/2 inch wrench.
	2. The shaft seal should remain on the motor shaft, or if leaking,
	should be replaced at this time.
	3. To replace the pump, remove the four allen screws, front plate,
	rotor, and rollers from pump (see Section 2-18). Place the pump
	onto shaft and against the shaft seal. Place the two 1/2 inch bolts
	through the pump and into the motor and tighten. Then replace the
	rotor, rollers, front plate and tighten the allen screws.
	When removing a pump from a motor note the positions of
	the INLET and OUTLET parts. Installation of the pump on
	the motor in any other position could cause damage to the
	fryer. There is an indicator on the side of the two halves of
	the pump, this mark must be together and face to the front
	of the fryer.

593 2-15