Henny Penny OE-100 manual REMOVING THE CONTROL PANEL Continued, Thermal Sensor

Henny Penny Model OE-100

2-3. REMOVING THE CONTROL PANEL (Continued)

2-4. THERMAL SENSOR

3.Panel will now swing out with hinge located on left side of panel.

4.Pulling down on the spring loaded hinge pin, pull control panel straight out to completely remove.

NOTE

When completely removing control panel, all wiring must be unplugged from control panel. Be sure to mark wires before removing.

5. Install panel board by reversing order.

The thermal sensor determines the shortening temperature. If a mal- function does occur, an E6 will be displayed on the digital readout. Turn unit to OFF position, then back to COOK position. If E6 is still displayed, the thermal sensor must be replaced by following these steps:

1.Remove electrical power supplied to fryer.

Place POWER switch in the OFF position and unplug the power cord or remove power from the fuse or breaker box.

2.Drain the shortening from frypot.

3.Remove two decorative strips located on each side of control panel and let control panel swing out.

593 2-2