Henny Penny OE-100 Continued, power cord to open the wall circuit breaker, 2-8.FAN, Contactors

Henny Penny		Model OE-100
2-7. CONTACTORS	The Henny Penny OE-100 requires two switching contactors. Lo-
(Continued)	cated on the bottom is the primary contactor with the heat contactor
	stacked to the top of the primary. When closed, the primary contactor
	completes the heat circuit. It also supplies power to the heat contactor.
	1.	Remove electrical power supplied to the fryer.
		Place ON/OFF switch to the OFF position and unplug the
		power cord to open the wall circuit breaker.
	2.	Remove the control panel. Refer to Section 2-3.
	3.	Perform a check on the contactor as follows:

Test Points	Results
from 23 to 29	open circuit
from 24 to 28	open circuit
from 25 to 27	open circuit
from 30 to 34	open circuit
from 31 to 35	open circuit
from 32 to 36	open circuit
from 22 to 26	ohm reading 415
from 33 to 37	ohm reading 415

2-8. FAN	The Henny Penny OE-100 has a fan in the circuit which operates only
	when the power switch is in the COOK position. The fan helps keep
	the control panel cool by pulling out heat from between the control
	panel and frypot.
	The replacement of a faulty fan is as follows:

To avoid electrical shock or other injury, before starting this procedure, move power switch to OFF position. Disconnect main circuit breaker or unplug cord at receptacle.

1. Remove control panel per Section 2-3.

593 2-8