Hitachi CP-X268AWF user manual Inserting an SD Card and USB Memory

Setting up

Inserting an SD Card and USB Memory

When using the projector with a wireless LAN please insert the included Wireless Network Card.

When using a commercial SD Memory card in order to view images insert the SD Memory card in the same manner.

And when using a commercial USB MEMORY in order to view images insert the USB MEMORY to the AUX I/O port. (13)

See User's Manual - Network Function for information on using either type of card.

1. Make sure the projector’s power switch is OFF.

2. Remove the SD card slot cover.

.Lift the cover slightly by the small indentation in the middle of the front of the FRYHUXVLQJD¿QJHUQDLORURWKHUPHDQV 3Pull the cover forward and remove it completely from the projector.

3. Insert the SD card.

Slowly insert the SD card completely into the SD card slot.

Make sure the angled corner of the SD card is facing the right side (AUX I/O port side) of the projector while inserting.

Indentation

AUX I/O Port

SD Card Slot

Angled corner

4. Replace the SD card slot cover.

Replace the cover by reversing the procedure used when removing the cover.

NOTE • When using the projector with a wired LAN, please remove the Wireless Network card.

•Select the "REMOVE MEDIA" on MIU menu before SD card or USB memory is removed.

NOTE • The LED becomes downward in some USB Memory. Remove the 86%0HPRU\DIWHUWKHDFFHVVLQJLVFRPSOHWHO\¿QLVKHG

IMPORTANT NOTE • To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co- located or operating in conjunction with any other antenna or transmitter.

16