Hitachi CP-X268AWF Power on/off, Turning on the power, Turning off the power, STANDBY/ON Power

Power on/off

Power on/off

WARNING ŹWhen the power is on, a strong light is emitted. Do not look into the lens of projector. Also do not peep at the inside of projector through a hole.

NOTE • Turn the power on/off in right order. Please power on the projector prior to the connected devices. Power off the projector later than the connected devices.

Turning on the power

0DNHVXUHWKDWWKHSRZHUFRUGLV¿UPO\DQG	STANDBY/ON	POWER
1. correctly connected to the projector and the outlet.	button	indicator

2. Remove the lens cover, and set the power switch to the ON position.

The power indicator will light up in steady orange. Then wait several seconds because the buttons may not function for these several seconds.

(1)When AUTO ON in the OPTION menu is set to TURN ON:(42) The lamp will only be automatically turned on when the Power switch is turned on after the power was turned off by Power switch last time. Afterwards the POWER indicator

will begin blinking in green. When the power is completely on, the indicator will stop blinking and light in green.

(2) When AUTO ON in the OPTION menu is set to TURN OFF please see step 3.

3. Press the STANDBY/ON button on the projector or the remote control.

To display the picture, select an input signal according to the section "Selecting an input signal" (20).

POWER

(Steady orange)

POWER

(Blinking in green)

POWER

(Steady green)

Turning off the power

Please pay special attention to below two points when you do:

(1)Please do not turn the projector on again for at least 10 minute in this case. Neglect could shorten the lifetime of the lamp.

(2)During use or immediately after use, do not touch around the lamp and vents of the projector (5 Ì) It could cause a burn.

(3) Remove the SD memory or USB memory before turn off the power switch.

1. Press the STANDBY/ON button on the projector or the remote control.

The message "Power off?" will appear on the screen for about 5 seconds.

Power off?

2. Press the STANDBY/ON button on the projector or the remote control again while the message appears.

The projector lamp will go off, and the POWER indicator will begin blinking in orange.

Then the POWER indicator will stop blinking and light in steady orange when the lamp cooling is complete.

3. Make sure that the power indicator lights in steady orange, and set the power switch to the OFF position. The POWER indicator will go

off. Attach the lens cover.

POWER

(Blinking in orange)

POWER

(Steady orange)

19