Hitachi DZMV350A instruction manual Removing Disc

Hold disc around this portion.

REMOVING DISC

1 Set the power switch to “POWER OFF” to turn the DVD video camera/ recorder off.

2 Press down the DISC EJECT button once and release it.

In a moment, the cover of disc insertion block will open slightly.

DISC EJECT

3 Gently open the cover until it stops.

When the cover is fully open, the disc will slightly come out from the disc guide, and stop.

4 Remove the disc.

Hold the top of Round

DVD Holder as showninthe

illustration and gently pull it out.

Note:

Be careful not to touch the disc exposed portion when removing the disc.

5 Gently push the section indicated “PUSH CLOSE” on the cover of disc insertion block, to close the cover.

Note:

•It is recommended that you turn the DVD video camera/ recorder off when inserting or removing disc, in order to prevent faulty operation.

•Even after the DVD video camera/recorder is turned on, the disc can be removed unless it is in recording status. Hold down the DISC EJECT button for approximately 2 seconds, and then release it to remove the disc. (The DISC EJECT indicator on the LCD screen will blink.) It is recommended that you turn the DVD video camera/ recorder off before inserting or removing disc to prevent misoperation.

•Do not detach the battery or AC adapter/charger until the DVD video camera/recorder is completely turned off.

•Do not insert anything other than the 8 cm DVD-RAM or DVD-R disc into the disc insertion block: Doing so could cause malfunctions.

•Set the power switch to “POWER OFF” to turn the DVD video camera/recorder off.

•When inserting or removing the disc, be careful not to touch the inside of DVD video camera/recorder (especially, the lens of laser pickup).

•When inserting or removing the disc, connect a charged battery or AC adapter/charger to the DVD video camera/ recorder: The disc cover will not open unless the DVD video camera/recorder is powered.

English

43