Hitachi DZ-BX31A, DZMV750MA No DVD Video Camera/Recorder Operation Check the Following, 169

No DVD Video Camera/Recorder Operation – Check the Following:

English

Check 1 No movie can be recorded

Movie can be recorded only on disc.

Check the following:

•Is proper type of disc inserted?

•Is power switch set to “O”?

•Is the DVD-RAM/DVD-RW (VR-mode) disc in DVD video camera/recorder write-protected? Release the write-protect.

•When using DVD-RW (VF-mode)/DVD-R disc: Has the disc been finalized?

•Does disc have remaining recording space?

If movie still cannot be recorded after the above check is clear, the disc may be damaged: Use another disc.

Check 2 No still can be recorded

Still can be recorded only on DVD-RAM disc or SD memory card.

Check the following:

•Is proper type of disc or card inserted?

•Is power switch set to match the recording medium?

−When using DVD-RAM disc: Set to “N”.

If the LOCK switch on this DVD video camera/ recorder is set to L(upper position), set it to K(lower position).

If the LOCK switch is set to L(upper position), switching to “N” is not possible.

−When using SD memory card: Set to “P”.

•Is loaded DVD-RAM disc write-protected?

•When using SD memory card: Is the erase prevention switch locked? (p. 28)

•Does disc or card have remaining recording space?

If still cannot be recorded after the above check is clear, the disc or card may be damaged: Use another disc or card.

Check 3	Skip or search playback does
	not work well

If the temperature inside the DVD video camera/ recorder is high, normal operation may not be possible. Turn the DVD video camera/recorder off, wait for a few moments, and then turn it on again for operation.

	• No operation can be
		performed because the
		ACCESS/PC or CARD
		ACCESS indicator on this
Check 4		DVD video camera/recorder
		remains lit or blinking.
	•	After disc or card is
		inserted, it takes some time
		until recording is possible.

In the following cases, it will take more time than usual until operation is possible:

•Immediately after a disc or card is reinserted.

•When a long time has elapsed since the DVD video camera/recorder was turned off last.

•When the temperature is greatly different from the status of previous recording.

•When disc with scratches, dirt or fingerprints is inserted.

•When disc is subject to severe vibrations.

•When the battery or DC power cord was disconnected instead of following the correct procedure using power switch to turn the DVD video camera/recorder off.

169