Hitachi DZGX20MA, DZMV750MA, DZ-BX31A, DZMV780MA Be careful of moisture condensation

Be careful of moisture condensation:

•When you move the DVD video camera/recorder between places where the difference in temperatures is great – such as entering a lodge from a ski slope or going out of a cooled room or vehicle – condensation (vapor in air warmed or cooled to water droplets) could occur on the lens and/or inside the DVD video camera/recorder. If condensation occurs, do not open the cover of disc or card insertion block if possible. If condensation occurs on the lens, wipe it off with a soft, dry cloth. Even if the external surface of DVD video camera/recorder has dried, condensation may remain inside: Turn the DVD video camera/recorder off and leave it in a dry place for at least 1 – 2 hours before using it again.

Do not use the DVD video camera/recorder for a long uninterrupted period of time:

•This DVD video camera/recorder cannot be used for a long time continuously as a surveillance camera/monitor. If you use it for a long continuous period of time, the temperature of DVD video camera/recorder could exceed the limit and the recording/playback operation may slow down or other faults could occur. If this happens, turn it off and wait for a while before using it again.

Do not turn the DVD video camera/recorder off while the ACCESS/PC indicator or CARD ACCESS indicator is lit or blinking:

English

•The ACCESS/PC or CARD ACCESS indicator is lit or blinking to show that data is being written to disc or card, or being read from it. At this time, do not do any of the following, so as not to damage the data:

−Remove battery

−Disconnect AC adapter/charger

−Plug or unplug PC connection cable

−Remove disc or card

−Subject DVD video camera/recorder to severe vibrations or impact.

−Violently open or close the LCD monitor

The ACCESS/PC indicator will light for a while after recording is finished. While it is lit, do not subject the DVD video camera/recorder to any vibration or impact, and do not disconnect the battery or AC adapter/charger.

If you turn the DVD video camera/recorder off while the ACCESS/PC or CARD ACCESS indicator is lit or blinking, turn it on again with the disc or card loaded in it: Repair of the disc or card will be executed automatically (see page 171).

ACCESS/PC indicator

CARD ACCESS indicator

Do not wipe the DVD video camera/recorder case with benzene or thinner:

•The coating of case could peel off or the case surface could deteriorate.

•When using a chemical cleaning cloth, follow the instructions.

Also read the instructions attached with optional accessories:

•For optional accessories, observe the cautions and follow instruction manuals attached.

The battery provided has not been charged at time of purchase:

•Charge it before using the DVD video camera/recorder (see page 40).

•The battery will discharge as time passes. (The battery is produced so that it discharges on its own in order to protect its characteristics.)

Disc cannot be inserted or removed unless a charged battery or AC adapter/ charger is connected to the DVD video camera/recorder.

Be sure to set the power switch to “OFF” when turning the DVD video camera/ recorder off:

•Disconnecting the battery or AC adapter/charger while the DVD video camera/recorder is being powered could cause a fault.

7