Hitachi DZGX20MA, DZMV750MA, DZ-BX31A, DZMV780MA instruction manual 179, During recording

Symptom	Cause and Correction	Reference
		page
Even if the DVD video	The DVD video camera/recorder will automatically turn on to
camera/recorder is off,	recognize a disc: Closing the cover will automatically turn the
opening the cover will	DVD video camera/recorder off.	47
cause the ACCESS
indicator to blink.

During recording

Symptom	Cause and Correction	Reference
		page
Pressing the REC or	Is input image copy-guarded?	28, 84,
PHOTO button will not	Is the disc write-protected or the card locked?
		136, 169
start recording.
Recording starts but	Is disc scratched or does dirt or fingerprint adhere to it?	27
stops immediately.	Clean the disc. If there is still no improvement, replace the disc.
	Is some other AV device directly connected to the video/audio
	input/output jack of this DVD video camera/recorder?
	If the AV device is connected via several other devices, such as	83
	AV selector, the video signal may not be transmitted incorrectly.
	In such a case, reduce the number of devices through which the
	video signal is transmitted, or connect AV device directly.
	Are you attempting to record image from video game or PC?
	From some video games or PCs, image cannot be recorded on	—
	this DVD video camera/recorder.
LCD screen is hard to	Has brightness of LCD screen been adjusted?	101
see.	Stop recording and adjust the brightness.
	Is the DVD video camera/recorder being used outdoors?
	Use the viewfinder. When using LCD monitor, adjust its angle so	36, 37
	that LCD screen is not exposed to direct sunlight.
Unevenness appears on	Did you press the LCD monitor or the area around it?
LCD monitor screen.	If the LCD monitor is pressed, some unevenness will occur.	—
	Release your hand and leave the LCD monitor for a while:
	Normal display will be restored.
Focus is not correct.	Is it difficult to use auto focus with your subject?	76
	Focus manually.
	Does “MF” appear?
	The DVD video camera/recorder is set to manual focus. Focus	75
	the subject manually, or release manual focus.
	Is the diopter control correctly adjusted if you are using the
	viewfinder as a monitor?	37
	Adjust the diopter control.
	In cases other than the above, set the power switch to “OFF”, and	45
	then set it to “O”, “N” or “P” again.
An error message for	Repair is only possible when the DVD video camera/recorder is
repair appears.	powered by the AC adapter/charger. Remove the disc, and then	44
	insert another disc: The removed disc can later be repaired by
	connecting the AC adapter/charger.

English

179