Hitachi HUS103030FL3800, HUS103036FL3600, HUS103073FL3800, HUS103036FL3800 Enable Delayed Start

Models: HUS103073FL3800 HUS103030FL3600 HUS103073FL3600 HUS103036FL3800 HUS103030FL3800 HUS103014FL3800 HUS103014FL3600 HUS103036FL3600

1 43

Page 41

No.	Option Jumper Connector (C3)				Meaning
1		Remove the Jumper Socket		Spindle motor automatically
		for C3-13,14 (Default)		starts when the power is on.
	1	13	23
	2	14	24
2		Install the Jumper Socket		Spindle motor starts in
		for C3-13,14		sequence via ID number x 10
	1	13	23	seconds from the time power is
	1	13	23	applied	(NOTE 1)
				applied

	2	14	24

Note 1. This time is as follows:

ID number 0 to 7 : ID number x 10sec

ID number 8 to 15 : (ID number - 8) x 10sec

Note 2. This jumper is valid only when Auto Start setting is done.

Note 3. If setting for Delayed Start is done by host via SCSI bus connector (C1) in SCA-2 LVD drive, remove jumper in C3-13,14.

Note 4. If DELAY START in SCSI bus connector (C1) in SCA-2 LVD drive is grounded by host, jumper setting in C3-13,14 is invalid.

Drawing No. Sheet No. Revision ６
K6610091	41/43	2005/2/23

Image 41