Remove Bolt | Hobart HPGF15 instruction

EXHAUST VENT

1-1/4" DIA. EXHAUST PIPE

DRAIN PIPE

EXHAUST TANK

Fig. 21

REMOVE BOLT

PL-40939-2

Fig. 22

5.Remove 4 screws holding exhaust tank in place (see Fig. 21) and remove exhaust tank.

6.Flush exhaust tank with hot water.

7.Reverse procedure to reinstall exhaust tank.

– 21 –

Image 21

Hobart HPGF15 manual Remove Bolt

Contents

Truct For Your Safety Important for Your Safety Table of Contents Unpacking Installation Installation Codes and Standards AssemblyLocation Installing Casters GAS Connections Exhaust Pipe Flue Connections Testing the GAS Supply SystemElectrical Connections Lighting Instructions PL-40937-1 PL-40936-1 Before First USE Operation Turning the Fryer on Filling the Kettle with Liquid Shortening Frying Procedure for ALL Foods Power Failure HIGH-LIMIT SwitchTurning the Fryer OFF Extended Shutdown Suggested Cooking Guide PRESSURE-RELIEF ValveTemp Food Other Items Which May Be Prepared in the Pressure Fryer Using the HMF50 or HMF85 FilterTemp Time Food Min Filtering Oil at the End of the Production Day Cleaning Daily Cleaning Stainless SteelAluminum Kettle Weekly Cleaning More Often if Required Solenoid Assembly Fig Cleaning After Every Production Period Exhaust Tank Kettle Tilt Lid Pressure-Relief Valve Monthly Cleaning Exhaust Tank Remove Bolt LID O-RING Seal Replacement MaintenanceOther O-RING Seal Replacements Kettle Pressure-Regulator Assembly Vent Cleaning Port Plug Screw Troubleshooting Symptom Possible CausesLid will not lock do not Operate Fryer